I was looking around my 2004 26M yesterday and got quite a shock when I found the top head of my port rudder badly cracked. I have only used the boat, that I purchased used two months ago, twice and think it was cracked when I got it. The inside edge of the bracket does look a little bent inward. I don't think the rudder will "fall off" right away, but I do think it either needs to be repaired or replaced.
Does anyone know of a good place to either repair or replace the rudder?
Also, is it wise to repair, or best to jsut replace? I called the Mac factory today, but had a difficult time getting through to anyone.
Thanks
Rich
Cracked Rudder...Where to get Replacement?
- richandlori
- Admiral
- Posts: 1695
- Joined: Wed Aug 18, 2004 8:08 pm
- Location: Living Aboard in Morro Bay, CA
- Contact:
- Dimitri-2000X-Tampa
- Admiral
- Posts: 2043
- Joined: Fri Jan 02, 2004 5:36 am
- Sailboat: MacGregor 26X
- Location: Tampa, Florida 2000 Mercury BigFoot 50HP 4-Stroke on 26X hull# 3575.B000
- Bobby T.-26X #4767
- Captain
- Posts: 906
- Joined: Mon Jan 05, 2004 10:48 am
- Sailboat: MacGregor 26X
- Location: Oceanside Harbor, CA
Since you purchased the 26M from another party (used), you have no warranty. That is, only the original owner is covered.
Call the Mac factory and ask for Bill in Sales. He can advise you accordingly.
He may tell you to call a Mac parts distributor such as Powersailing Center http://www.powersailing.com/macgregorre ... parts.html
Call the Mac factory and ask for Bill in Sales. He can advise you accordingly.
He may tell you to call a Mac parts distributor such as Powersailing Center http://www.powersailing.com/macgregorre ... parts.html
