Re: We are in love with our new to us Mac! :-)
Posted: Sun May 27, 2012 8:36 pm
well, I didn't get on the water today.
It was a lot more work then I wanted to set up the boat, we raised and lowered the mast 3 times. I think I am missing parts on a lot of my boat, I will be posting photos tomorrow in a new thread for advise. The mast raising system is good, though my winches are so worn they slip. I think the for/aft stays are too tight, also we install a roller furler that came with the boat. Anyway, next time out I dump it in the water, and see if the engine works. I don't even know how to hook it up, what gas/oil mix it takes if any, or how to start it (evenrude 50).
TTYL take ti easy folks.
Kev.
It was a lot more work then I wanted to set up the boat, we raised and lowered the mast 3 times. I think I am missing parts on a lot of my boat, I will be posting photos tomorrow in a new thread for advise. The mast raising system is good, though my winches are so worn they slip. I think the for/aft stays are too tight, also we install a roller furler that came with the boat. Anyway, next time out I dump it in the water, and see if the engine works. I don't even know how to hook it up, what gas/oil mix it takes if any, or how to start it (evenrude 50).
TTYL take ti easy folks.
Kev.