Back rest cushions for :macm: Back rest for :macm: (Rigid one on starboard side in front of stock cooler location) Single burner butane stove missing grill hardly used BWY genoa track ladder -SOLD Stock Doyle jib -SOLD Stock Doyle Main -SOLD yukonbob, I guess the swap is off for me since you have n...

yukonbob wrote:Also jib has a small wear hole from the sock near the head an from what I remember is smaller than a dime. Main has no issues I remember.

OK,
I will take the main and jib for my for the $60.00 shipping.
Thank you

yukonbob wrote:Back rest cushions for
Back rest for
Single burner butane stove missing grill hardly used
BWY genoa track ladder
Stock Doyle jib
Stock Doyle Main

I could use a main and a jib for my
What condition?
Please let me know what shipping will be to 48161.

Thanks!

What is you intended use and location for these

Thanks for all the info....right now I just want to add a cheek block to the top of the original daggerboard cheek. :?: I am still not sure how to get to the thru deck bolts for that cheek block :?: . I have a 2011 M, and the only thing that looks like it might be an access is the fake wood "ce...

what I did works perfectly. No undue stress on any of the hardware. ...At least on our boat, the bolts holding the cheek turning block were long enough to stack the second block on top of it without a problem. The hardest part (not really hard) is to remove all the foam to access the nuts..and you ...

Sounds easy enough....but exactly how are you securing the spreaders to the mast? Do you leave the endcaps attached to the shrouds? David Or just spend $5 and buy 2 hitch pins to replace the bolts. remove the spreaders when lowering the mast. Secure them to the mast while trailering. No chance of ru...

Anyone ever hear a reply from Mike at the Factory on this? After setting up my new '11 :macm: a few times the lifeline / spreader battle is really a pain, I have researched this forum, and found quite a bit of info on the subject, but I really would like to know what the Factory solution is. I did r...

Looking for some photos that show good detail of Outboard Install. About to have Dealer Install New Merc 50 Bigfoot on my new M, and he has never seen a Macgregor 26M. The plan is to use the Uflex controller just like in the sales booklet. Would like some photos of how things are supposed to look in...

Hi Mike, I Just took delivery on a new 2011 26M here in Michigan last Friday from The Sailboat Center, can you please extend me the same deal as you promised Norca (see below)? Thanks, David :macm: Hi Norca, Get it now. If you send me info on your new boat purchase from any dealer, before this month...