I have a 2009 26m with an envirude 50hp motor. I need to replace the prop, but cant find the size, pitch etc. I read somewhere that a 4 blade prop is better for pulling towables. Any suggestions for size and pitch for 3 and 4 blade? On a side note: im looking for a 3 person towable with low drag. An...

my bad..you are right... its a perko switch and all contacts are positive. That's what i get for working on the boat late at night! I found the problem. I checked the inline fuse and it was ok. then did a continuity check form both ends of the inline fuse holder to the fuse pannel. only the near sid...

lost all power to cabin. when checking the perko switch i have 12+ voltage to #1 and #2 and "all".. ( tested with positive lead of volt meter to switch terminal and negative lead to battery) . When touching negative end of the meter lead to perko ground I get zero voltage. I checked the gr...

The Tachometer on my 26m quit working. All the indicator lights work (oil, etc). checked all wires and batteries are charging ok. If it was a wiring problem, would the warning lights still go through their start up check? I have an etec 50hp. is there a way to test the tach before buying a new one? ...

thanks,, i will look for it tomorrow!

The rubber trim around the interior wood window trim wont stay in the tracks on my 26m..any ideas what to use to make it stick in tracks? Im afraid to use epoxy that would make it permanent. thanx ...you all have been great in helping me get my mac back in the water..hopefully in a few a weeks.

has anyone heard of "bolster buddy" seats?

https://bolsterbuddy.com/#!/c/0/inview= ... t=priceAsc

my wife and I are short in stature (she is 4'8"). I would like to find a seat we can put on the captains seat that would give us a little more height. It would have to be detachable. any ideas out there? I have looked at seats for fish boats, but they all connect to a pedestal or brackets. No &...

"mean green with bleach" only costs about $3..dont let it sit too long..takes off even those pesky little black spots. Make sure it the green with bleach.

I replaced a broken spreader and was wondering how to remove the old spreader tip? I removed the bolt and tried twisting/pulling the tip with no success. Is there a trick to getting it off? (just wanted to save it for a spare part).

Thanx capt Jack! I connected the transducer cable from the mast directly to the back of the st40 and it worked perfectly! Now all I have to do is replace the plug. should I change the 4 pin plug to two 2 pin plugs? Thanks again for your help..its so simple, I cant believe I didnt try it earlier. :ma...

I have a Rotavecta wind transducer mounted to the top of my mast. It seems Iam not receiving any signal from the transducer. I sent the st40 in to raymarine and it was checked ok. I have continuity from the A60 sea talk to the st40 and continuity from the st40 to the mast electrical plug on the deck...

thanx...I went the barbeque cover route... my wheel is 20"...

I have an oversized steering wheel on my 26m. The cover I had on it didnt fit right and finally blew away in a strong wind. Does anyone know of a pattern to make a pedestal cover? Or have any ideas how to make a cover that covers the wheel and pedestal? thanx

I have the same set up and same problem. It seems i need a third hand. I tried re adjusting the shrouds, but then they are too loose after the forestay is finally connected.. I will watch here for any other ideas...thanx